Solderless Custom RCA Cable System – Dual Coaxial Cable

Note: ONLY use supplied tool to cut the cable. Cable is sold by the Foot. 

Our Solderless RCA System is exactly what we have been using at Vanguard Automotive Design for some time now. These allow you to cut your RCA cables to size, and install the RCA ends easily by simply cutting the cable, adding the head to the end, and screwing down a small flat-head set screw. Your cables can be made in less than 30 seconds. No need to break out the solder station, magnifying glass, and helping-hands and spending 10 minutes just to strip a few small wires and solder on two RCA ends. This system is as easy as it comes. 

The cable is standard 75-ohm coaxial cable, but still has plenty of flexibility to use in automotive installations. They look clean and sleek and are not stiff and bulky like most high-end cables are. The cable comes as a side-by side pair design, so  just like normal RCA’s, they act as a pair. That said, they are easy to split if you are doing custom wiring work.

Also Available For Our Solderless RCA Cable System:

Solderless RCA Cable

Black Chrome RCA Connector Ends

Silver RCA Connector Ends

RCA Y-Splitters

Right Angle RCA Connector Ends

Female RCA Connector Ends

Cable Specs

. Made in USA

. Side-by-Side design acts as a PAIR of channels 

. Meets 75 ohm HD standard

. TPE Jacket

. Max Bend Radius 2.25 inches

. Sweep-tested 3GHz over 100ft with nominal db loss

. Nominal Capacitance 18.2 pF/ft / Premium oxygen-free copper

. 100% shielding with 95% tinned copper braid & tin foil shield

. CM & CL2 rated for in-wall installations

. Nitrogen-gas-injected foam PE dielectric

. Max Pulling Tension 2359 PSI

. Max Bend Radius 2.25 inches